10-80 kpa army green BK 6015 Three Roots Blower for waste water treatment

We have RSR/MTS/MTRR/MTRG/MTRH/MTRF/MJSR series roots blower,10-80 kpa army green BK 6015 Three Roots Blower for waste water treatment,three lobe roots blower， roots vacuum pumps and the related products, which is widely used in sewage treatment, chemical plant, MVR project, cement plant, electric power plant, fertilizer plant, paper producing, coal mill, textile mill, food plant, aquaculture, vacuum package, metallurgy industry and many other industrial,three lobe roots blower
GGHGA
i,10-80 kpa army green BK 6015 Three Roots Blower for waste water treatment Low noise
three lobe roots blower with adoption of helical tri-lobe roots rotors and the discharge port of special geometry, the airflow noise is much lower compared to typical straight-lobe roots blower. The noise level can be reduced by 8db in the band of low frequency; hence the noise in the surroundings of blower can be significantly improved.
HDHSD
ii, 10-80 kpa army green BK 6015 Three Roots Blower for waste water treatment High adiabatic efficiency
three lobe roots blower with design of helical tri-lobe roots rotors, the airflow pulsation is less and the air streamline would be more stable. Therefore the fluctuation in airflow is less and then the energy waste can be reduced.
SSFFS
iii, 10-80 kpa army green BK 6015 Three Roots Blower for waste water treatment Super Energy saving
three lobe roots blower Compared to the typical roots blower under the same operation conditions of discharge pressure and airflow volume, the power consumption of helical tri-lobe roots blower will be lower by 20.
OASAD

BK Type Roots Blower Main Advantage

Optimized lobe curve is sdopted for reducing blower's internal leakage, improving blower's efficiency and reducing running

temperature. After radius-center distance ratio n10-80 kpa army green BK 6015 Three Roots Blower for waste water treatmented and shaft's diameter enlarged, no deformation and collision will occur under

higher load pressure as the blower's strength is improved.

Unique hollow design of end-cover is used for making bearing cavity separated from gas chamber relatively, by which reduces the

impact of inside high temperature gas on bearing cavity and lowers the bearing temperature. Deep groove ball bearing of high

precision and low friction factor is selected for lowering operation boise.

In addition, because of larger size bearing matched for enlarged shaft diameter, the bearing's load capacity is enhanced and its

service life is extended.

B-TOHIN MACHINE

10-80 kpa army green BK 6015 Three Roots Blower for waste water treatmentING ON ENVIRONMENTAL PROTECTION INDUSTRY

Blower working principle

Roots blower is a cubage blower, and it discharges a fixed amount of air in proportion to its rotation speed. Every rotation, there is two lobes to finish three times absorbing and discharging air. Compared with two lobes blower, it is of less air pulses, smaller load change, higher strength, lower noise and vibration.Two parallel shafts have three lobes each, all the lobes keep smll clearance with each other and housing inside. Every lobes ritation, a certain air will be absoabed at inlet and transferred from the housing inside surface to blower's discharge port.

Two shafts will be turned by the timing gears,no any touching between lobes, so it can be turned at high speed without any lubrication inside. It has the following characteristics: Simply configuration; running smoothly; good performance stabilization. It has been widely applied in various industries.

Internal Structure Sketch